How to build a vintage style storage dining table. Free woodworking plans by Ana-White.com
- 1 - sheet 3/4" plywood ripped into strips 19", 22" and 5 1/2" , all 8 feet long
- 1 - 1x2 @ 4 feet long
- 1 - 2x2 @ 6 feet long
- 1 - 1x4 @ 6 feet long
- 50 x 36 tabletop
- 2 - knobs or handles
- 2 - 3/4" plywood @ 19" x 29 1/2"
- 4 - 1x6 @ 5 3/4"
- 2 - 1x2 @ 17 1/2"
- 2 - 3/4" plywood @ 22" x 27"
- 2 - 1x6 @ 36"
- 2 - 2x2 @ 36"
- 1 - Tabletop 50" x 36" (planked or you can use plywood trimmed or edge banded)
- 2 - 1x4 @ 17 1/2"
- 2 - 1x4 @ 16 3/4"
- 1 - 1/4" or 3/4" plywood @ 17 1/2" x 18 1/4"
- 2 - 1x6 @ 18 1/4"
When you cut your panels from plywood, consider ripping into strips 19" and 22" wide, and then cutting your pieces from those strips. This will ensure greater accuracy. To save on materials, consider cutting scraps into 5 1/2" wide widths and using these strips to replace 1x6 boards in plan.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Take your time drawing carefully out your end patterns. The ends do not have to match my suggestions, but they do have to match each other. Once you have one cut, use it as a pattern to cut the other. Clamp the two cut ends together and sand all rough edges until the two match. Then attach to the center storage area with screws and glue.
You can make your tabletop from just about anything. The best solution is joining hardwood boards together on the underside with 3/4" pocket holes and 1 1/4" pocket hole screws. Another option is to use 1/2 sheet of hardwood plywood, cut to 47" x 33". Then attach edge to edge 1x2 frame around all sides to create a sturdy and decorative wood edge to the tabletop. Would be beautiful in Purebond Plywood for sure!
And then just position the drawer faces over the drawer boxes, shimming so there is an even 1/8" gap all the way around, and attach with 1 1/4" finish nails. Then also attach from inside with 1 1/4" screws. TIP: Attach hardware first to drawer face so you don't have to drill through a second layer of 1xs to access the hardware screw - depending on your type/style of hardware.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.