Router table w/ rockler table, fence and lift

Submitted by 1n4001 on Fri, 11/02/2012 - 08:19

Built Patrick's Router table and added a rockler table, fence, and lift to finish off.

Built from Plan(s)
Estimated Cost
~$90 in lumber and hardware + ~$460 for table top, fence, and lift + $170 for bosch 1617evs router
Estimated Time Investment
Day Project (6-9 Hours)
Finish Used
raw, probably sand and spray some poly on it in the near future.
Recommended Skill Level
Intermediate

Comments

Patrick Hosey (not verified)

Fri, 11/02/2012 - 09:10

Yes! Enjoy. It'll be the most valuable tool in your shop trust me.

patrickhosey

Sat, 11/03/2012 - 19:28

Here's a tip for that 1617 router. Try putting a bandaid over the on/off switch. That thing will get gummed up if left uncovered. It's annoying.

jimssolidwoodp…

Sun, 03/05/2017 - 21:13

My question for Patrick is when he built the top section for 2 small drawers and middle section for the router access..

Did Patrick put on top a 3/4" pc of plywood then the router table top.

Can l attach my router table top to the top pc if 3/4"plywood then my table top is 1 3/4" thick that it would be to thick could you email to let me know please.

Jim