End table with drawer.

Submitted by dtmagnet on Mon, 10/06/2014 - 17:24

Used the plans for the Rustic X End Table on this site, modified them a bit to fit the space I wanted to fill. Also changed the design a bit to incorporate a drawer. I wire brushed each piece with a wire wheel brush drill bit to give it texture and make the grain come to life, then after assembly I went over the whole thing with a blow torch to add some nice colour and make the grain further stand out. Finally finished it off with minwax classic grey stain. I'm very pleased with how it turned out.

Built from Plan(s)
Estimated Cost
$40
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Wire brushed and burnt with a blow torch, then stained with minwax classic grey.
Recommended Skill Level
Intermediate

Comments

Wifey

Sun, 11/02/2014 - 20:57

Looks nice. Any notes as to how you incorporated the drawer?