Taylor Console Table

free console table plans farmhouse style ana white
Difficulty
Intermediate
| Print this plan

Free woodworking pattern to build a substantial, rustic console.  This console table can be used under a tv, behind a sofa, as an accent table, or even as a bathroom vanity.  The 4x4 legs give it a high end look, but you can DIY it with our free plans for much less.

Built by Whitney from Shanty2Chic

free console table plans farmhouse style ana white
wood console table with free plans

diy wood console table free plans

diy wood console table free plans

FAQ

What finish was used?  Please visit  Whitney from Shanty2Chic for more details

Do I have to use caster wheels?  No, of course not.  If you skip the casters, just make the legs 28-1/2" long instead.

Can I use 2x4s instead of 4x4s?  Yes!  It will affect the dimensions, so I'd advise cutting as you go.  

Pin For Later!

Taylor Console Table

Dimensions
console table plans
Dimensions shown above

Preparation

Shopping List
  • 2 - 2x6 @ 10 feet long
  • 1 - 4x4 @ 10 feet long
  • 1 - sheet 1/2” plywood for bottom shelf, or substitute 3 - 1x4 x 10' boards
  • 4 - 2x4 @ 8 feet long (cut 50” cuts first)
  • 2 1/2” pocket hole screws
  • 4” overall clearance caster wheels
  • 1-1/4" brad nails
Common Materials
1 1/4 inch finish nails
Cut List
  • 4 - 4x4 @ 24 1/2” (extend length to 28-1/2" if not using caster wheels)
  • 4 - 2x4 @ 50”
  • 4 - 2x4 @ 14”
  • 3 - 2x4 @ 17”
  • 1 - 1/2” plywood @ 21” x 57” (or 1x4 boards, see step 4)
  • 2 - 2x4 @ 9 1/2”
  • 4 - 2x6 @ 59”
Tools
Tape Measure
Speed Square
Pencil
Safety Glasses
Hearing Protection
Kreg Jig
Drill
Circular Saw
Jigsaw
Brad Nailer
Power Sander
General Instructions

Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!

Instructions

Step 1

Attach aprons to legs using pocket holes.

Step 2

And then attach side aprons to legs - it will start looking like a console here!

Step 3

These supports will keep that bottom shelf from sagging - not essential if you are storing blankets though.

Step 4

Once the top goes on, you won't be able to get the plywood in, so best to do that now. You could also use 1x boards on top for a planked look, or cut the plywood in 2 pieces down the center - it will get hidden by the center supports.

1x modification: 2 - 1x4 @ 50" and 4 - 1x4 @ 57"  Notch out the 2 1x4 @ 50"

Step 5

Attach the top sides to the legs with pocket hole screws on the inside.

Step 6

TIP: Drill 1 1/2” Pocket holes on insides of front/back aprons, facing upward, for attaching the top in later steps, prior to attaching aprons to legs. TIP: If you don't have a right angle drill, you may wish to do the next step (step 7) first as you may run out of room for your drill to fit. Followed by the front and back aprons.

Step 7

And then add these guys in the middle with 1 1/2" pocket holes and 2 1/2" pocket hole screws and glue.

Step 8

Build the top first, and then attach through the aprons with 2 1/2" pocket hole screws and glue.

Step 9

Add caster wheels to the base - all done!

Finishing Instructions
Preparation Instructions
Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth.

It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
Seasonal And Holiday