This is a serving tray that I made. Fairly simple to make. It has come in very handy. This tray is perfect for breakfast in bed on Mothers' Day or for birthdays. It is also helpful when grilling outdoors to carry out all the seasonings, meat, utensils, etc.
1x12 - 2' (srap)
1x4 - 6'
1x2 - 2' (scrap)
.75" dowel = 26"
A – Qty=1-(bottom of tray from 1 x 12 board): 11.5” x 21” x .75”
B – Qty=2-(sides of tray from 1 x 4 board): 27” x 3.5” x .75”
C – Qty=2-(ends of tray from 1 x 2 board): 11.5” x 1.5” x .75”
D – Qty=2-(dowels for handles): .75” dowels cut to 13” length
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
1. Transfer handle pattern to ends of side boards (B)-handle pattern on a one-inch grid shown below
2. Drill .75” holes in ends of side boards (B) per the pattern – tip: put a piece of scrap wood under the board that you are drilling to minimize “tear out” to the other side of the hole you are drilling.
3. Cut side board (B) to shape by using a jig saw
4. Thoroughly sand the board to smooth the edges that were cut in step 3
6. Glue dowels (D) into holes in side boards (B) and quickly glue and nail to the bottom (A) using 1.25” nails – tip: you should dry fit this together to make sure all is going to fit well before you apply glue. You want to attach dowels first, then attach to the bottom, but don’t let the glue set on the dowels so that you can make sure everything is squared up and flat before you nail to the bottom. (Clamps help, but glue and nails should be adequate)
7. Remove excess glue before it hardens – it sometimes helps to let the glue set for 15-20 minutes so you can remove it while it is still a bit rubbery.
9. Add stain or paint