Adding an arch can be simple to do an add that extra touch of fancy to the simple bed. This is a modification of the simple bed plans. Special thanks to one of our readers for sharing their photo.
Pin For Later!
4 - 1x6 Boards, 8' Length 4 - 1x4 Boards, 8' Length 2 - 4x4 Posts, 8' Length 1 - 2x4 Board, 8' Length 3 - 2x2 Boards, 8' Length 3 - 2x6 Boards, 8' Length
8 - 1x6 cut at 38 1/2" (these are the headers) B) 6 - 1x4 cut at 31 1/2" long for the headboard (these are the rails) 6 - 1x4 cut at 21 1/2" long for the footboard (these are the rails) C) 28 - 1x6 cut at 2 1/2" long (if these boards are splitting on you - depending on your type of wood - use 28 1x3s cut at 5 1/2" long) (these are the spacers) D) 2 - 4x4 Posts cut at 41" 2 - 4x4 Posts cut at 31" E) 1 - 2x4 cut at 45 1/2" (Top of the Headboard) F) 1 - 2x6 cut at 47 1/2" G) 1 - 2x4 cut at 46 1/2" (Top of the Footboard) FOR THE FRAME (Where the Mattress Goes) H) 2 - 2x2 cut at 73 1/4" (Siderail boxspring holder) I) 2 - 2x2 cut at 35 1/2" (Siderail boxspring holder) J) 2 - 2x6 cut at 72" Siderail
Take four of boards A and mark out the exact same arch in the panels. In the bed shown, the arch starts 6" in on either end and is 3" tall at the center point. Carefully cut out these arches using a jigsaw. Layout the headboard and footboard panels, as shown below. The below diagram does not show the arches cut out. This diagram shows how the spacers (C) are to be placed between each of the rails (B). Start with only 1 of the arched header boards and a straight header board on the bottom. NAIL ONLY THE SPACERS AND THE OUTERMOST RAILS - DO NOT NAIL THE MIDDLE 4 RAILS. Use 1 1/4" nails.
Add the 2x4 (Board E)to the top of the headboard as shown below. THE ARCHED HEADER 2X4 WILL FIT FLUSH WITH THE TOP OF THE BED. THIS IS NOT SHOWN BELOW. Add the 2x4 (Board G) to the top of the footboard. Board G will overhang the posts by 1/2" on both ends. On the headboard, add Board F to the top of Board E, allowing a 1" overhang on all