Free plans to build a kids storage play table with flower top.
Now for the Make 2 Challenge! Did you make two this Holiday Season - one to gift and one to give? Please share below. If you don't blog, you can link up to photos anywhere online, or even brag on this site and link up. Thanks for joining me in doing a little something extra this Holiday Season!
1 - 2x2 @ 8 feet long 1/2 sheet of 3/4" thick PureBond Formaldehyde Free Plywood
1 - 3/4" plywood 31 1/2" x 31 1/2" (Used for tabletop) 4 - 3/4" plywood @ 2 1/2" x 15 3/4" (Aprons) 4 - 2/4" plywood @ 6" x 15 3/4" (Storage Sides) 1 - 3/4" plywood @ 15 3/4" x 15 3/4" (Bottom of storage compartment) 4 - 2x2 @ 22" (Legs)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
When cutting plywood, it's best to make long, straight full cuts to conserve plywood and get your straightest cuts. First things first - cut with the grain of the plywood a strip 6" wide and 48" long. Then cut another strip with the grain of the plywood 2 1/2 wide by 48" long. Now from the remainder, cut crosswise for the tabletop, 31 1/2" long by approximately 40" wide. Cut your tabletop from this piece. Then from the remaining pieces, cut your storage bottom and the remaining pieces for the side and apron. Use the cut list for exact dimensions. The above diagram does not take into account saw blade widths - so measure, cut, measure, cut and so on.
Now let's build the table base. Drill two 3/4" pocket holes on each end of each storage side, and attach to legs, flush to insides, with 1 1/4" pocket hole screws. What I like to do is build two leg sets made up of one side and two legs. Then it's a cinch adding the two final sides to create the base.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.