How to build laundry basket dressers! Clean up your laundry room with these simple laundry basket dressers made from a single sheet of plywood.
1 - Sheet 3/4" plywood or MDF 2 - 1x2 @ 8 feet long 2" screws or 1 1/4" pocket hole screws 1 1/4" finish nails Glue Paint 4 Laundry Baskets, 16" x 24" (I use the cheapo Sterilite ones but measure and make sure the baskets you buy will fit)
3/4" plywood cut as follows and shown in cutting diagram: Back: 17 1/2" x 48" Sides (2): 25" x 48" Top & Bottom (2): 19" x 25" 8 - 1x2 @ 24" (it's okay if they are a tiny bit short to get all the cuts on the same boards)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Okeedok! Here we go. Just start at one end of the plywood, measure in 17 1/2" and make a straight line and cut. Then measure in 25", mark a line and cut. Repeat two more times. From the last 25" strip, cut into two pieces 19" wide for the top and bottom. Because the saw blade takes up space when cutting, you cannot just mark all cuts and have at it. You must measure, cut, then measure, cut and so on. If you have a hardware store that will make these cuts for you, by all means, beg and plead. It's much easier to carry the pieces than a full sheet of 3/4".
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.