With two shelves and a drawer, necessities for baby like diapers, wipes, and lotions, can be kept within reach. A beautiful footer adds charm to this piece. Works with the rest of the Madeline Collection of plans.
1 Sheet of 3/4″ MDF or 3/4″ A1 Plywood, cut into 1×16 boards
1 – 1×6 Board (you only need about 5′ feet)
1 – 1×2 Board (you only need about 3′ feet)
3 1/4″ Floor trim or base moulding
3/4″ Edge Trim (3/4″ wide)
1 – Wood Knob
1 1/4″ Nails
Optional 12″ Drawer Slides, side mount, 1/2″ overall clearance on the sides
Knob for drawer
Please note that I choose to build these plans 16″ deep as opposed to 19″ to conserve building materials (you can get 50% more 1x16s out of a sheet of plywood or MDF than you could get 1x19s out of the plywood or MDF). Changing pads are tradditionally 16″ wide. You can modify these plans for a wider depth by using a wider width plywood or MDF strip.
And yes, the cubbies will fit the Pottery Barn Kids storage boxes.
Cutting List for the Box
2 - 1×16 @ 33 1/4″ (Sides)
3 – 1×16 @ 14 1/2″ (Shelves)
1 – 1×16 @ 16″ (Top)
Cutting List of Trim
2 – 1×2 @ 14 1/2″ (Inner Trim)
1 – 3/4″ Edge Trim @ 16″ (Front Edge Trim)
1 – 3 1/4″ Base Moulding or Floor Trim @ 16″ (Base Moulding)
Cutting List for Drawer
2 – 1×6 @ 14 1/2″ (Drawer sides)
1 – 1×6 @ 12 3/4″ (Drawer back)
1 – 1×6 @ 14 1/4″ (Drawer Face)
1 - 1×16 @ 12 3/4″ (Drawer Bottom, trim the width down to 12 3/4″ x 13 3/4″)
Build the Box. Start by marking your sides as shown in the left of the diagram above. Mark both the inside and the outsides of the side boards so you know where to fasten and where to line the boards up at. With the sides marked, fasten the shelves in place, keeping the front edges flush. Then fasten the top in place.
Drawer Construction. First cut your drawer bottom from the 1×16, length of 12 3/4″. Then cut the width side down to 13 3/4″ (completed dimensions should be 12 3/4″ x 13 3/4″). You must cut the drawer bottom perfectly square. Then fasten the drawer back to the bottom. Then the sides to the back and bottom. Use 2″ nails and glue. You may wish to inset the bottom up 1/4″. The easiest way to do this is use a scrap piece of plywood 1/4″ and rest the bottom on the scrap. Then fasten the sides. Make sure you build a square drawer.
Finishing. Fill nail holes with wood filler and sand and finish as desired. Add the front knob.
We apologize if there was an error in this plan. Please help us out and report any errors here.