How to build a drop leaf storage table with free, simple, step by step plans from Ana-White.com
Good luck building your own drop leaf storage table and please share photos with us when you are done! Can't wait to see!
2 – 2x2 @ 8 feet long
1 – 1x4 @ 8 feet long
2 – 1x3 @ 8 feet long
2 – 1x12 @ 8 feet long
1 – ½ sheet ¾” plywood
2 - sets of basic hinges
2 - Drop Leaf Support 8 inch Pair
4 - 2" caster wheels
4 – 2x2 @ 26 ¼”
2 – 1x4 @ 15 ¾”
4 – 1x3 @ 15 ¾”
2 – ¾” Plywood 15 ¾” x 28”
2 – 1x4 @ 28”
4 – 1x3 @ 28”
4 – 1x12 @ 42”
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
What I actually did here was build my tabletop with a row of 3/4" pocket holes/ 1 1/4" pocket hole screws down the center (and glue) and attached to tabletop. Then I attached the two leaves, so the tabletop is a giant square. Then I drew out the arch shape I liked and cut with a jigsaw.
Here's a video on cutting arches with a jigsaw. Just be very careful to make sure your jigsaw blade isn't beveling as it cuts the wood, and go slow. Use a very sharp, appropriate blade. And remember, you can always take more wood off later! Practice, practice!
I also posted a step by step tutorial on how I finished this table here.
And we waited two weeks for these to come in the mail and they were worth it! They are called Drop Leaf Support 8 inch Pair and no, they are not rock solid, but they are plenty sturdy for our purposes and install in seconds! I recommend installing them about half way down the table apron - you may need to do a little trial and error to get things just right.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.