This simple changing table features is basically a bookcase with a removeable topper, enabling you to convert back to a changing table. Features two large shelves and a divided topper, perfect for a changing pad and keeping baby necessities at hand.
Today, when I checked the mail, there were two baby shower invites. Two. Time for some changing table plans. Simple ones.
That fits a standard changing pad and has a little space on top for those items that you must grab when you don't have a free hand. I remember when Grace was a baby, we lived in the garage, slept on a mattress on the concrete floor, and an old card table served as a changing table. And the changing table kept me sane. I'm so glad that you might be able to have something better for your baby.
2 – 1×2 Boards, 8′ Long
1 – Sheet of 3/4″ MDF or Plywood, cut into 15 1/2″ wide and 8′ long strips (these strips will be referred to as 1×16 boards)
1 – 10′ 1×4 Board
4 – 1×3, 8′ Long
12′ of edge beading, 3/4″ thick
1 1/4″ Screws
1 1/4″ Nails
4 – 1×2 @ 34″ (Legs)
2 – 1×4 @ 15 1/2″ (Top Trim, Ends)
4 – 1×3 @ 15 1/2″ (Shelf Trim, Ends)
4 – 1×16 @ 40″ (Shelves)
4 – 1×3 @ 38 1/2″ (Shelf Trim, Sides)
2 – 1×4 @ 38 1/2″ (Top Trim, Sides)
2 – 1×3 @ 15 1/2″ (Topper Trim)
2 – 1×3 @ 41 1/2″ (Topper Trim)
1 – 1×2 @ 7 1/4″ (Topper Partition)
1 – 1×2 @ 15 1/2″ (Topper Partition)
Work on a clean level surface. Measure out all joints and mark before fastening. Be safe and use glue. Have fun! And predrill all screw holes before fastening.
Build your ends as shown above. Use 2″ screws and glue unless you have a Kreg Jig™ and you can fasten the end trim from the insides.
Fasten the shelves to the end trim pieces as shown above. Again, 2″ screws and glue or use the Kreg Jig™ from the underside of the shelves. Keep the top edge flush on the shelves.
SHELF SIDE TRIM
Trim out the shelf sides as shown above, use 2″ screws and glue. Fasten the trim to the legs to for extra support on the shelves from the outside of the leg or use a Kreg Jig™.
We apologize if there was an error in this plan. Please help us out and report any errors here.