Kitchen Island

Submitted by grant862 on Sat, 12/01/2012 - 19:05

Stuck to the plan as described, but I used my Kreg jig to use pocket holes where I could. I used 1x4s for the shelves and joined them together with pocket holes. This made it much stronger. Without joining these boards, the shelves are kind of flimsy, not sure how much weight they could support without some type of support system. I added an extra 2x4 to the top, this made it overhang about an inch on the front and back. I used 20" drawer glides. Also, I notched out the side supports for the 1x4 shelves 3/4" so the shelves sit flush with the side supports.

Built from Plan(s)
Estimated Cost
150
Estimated Time Investment
Week Long Project (20 Hours or More)
Finish Used
Sanded, then painted bare wood with 2 coats of paint, color was one of the pottery barn 2012 colors. I filled in the joints between the 2x4s for the top with stainable woodfiller, then sanded for like 2 hours with 80 grit, then finished off with 220 grit eventually, then I did 2 coats of Minwax Special Walnut stain. I topped that with 3 coats of Minwax Polycrylic Satin.
Recommended Skill Level
Beginner

Comments

maculpepper

Fri, 12/27/2013 - 12:35

Just had someone build this for me, I'm wondering what paint color is on the bottom of yours? It looks great with the stain you chose!

Jamison

Sun, 03/15/2015 - 17:00

Great table! I'm currently building a similar kitchen island and was debating going the cheaper route of utilizing 2x4s instead of making a butchers block. How did the wood filler between the boards work out for you as a flat surface? Has it cracked at all? Thanks in advance!