Country Kitchen Island

Difficulty
Intermediate
| Print this plan

Wanted an enclosed kitchen island with a farmhouse feel

Preparation

Shopping List

2 - 4x4x8
5 - 2x4x8
13 - 1x4x8
1 - 2x12x8
1 - 1x10x8
1- 1x8x8

Common Materials
Cut List

Currently verifying cut list, this is off memory below

4 - 4x4 x 34 1/2 " (Legs)
6 - 2x4 x 37" (Long Rails)
4 - 2x4 x 28" (Cross cuts for legs)
2 - 2x4 x 21" (side rails)
46 - 1x4x 10 1/4 " (outside slats)
12 - 1x4 x 42 1/2" (shelf slats)
4 - 1x4 x 21" (inside slat supports sides)
2 - 1x4 x 40" (Inside slat supports back)
2 - 1x2 x 37" (front shelf lip)

Tools
Tape Measure
Speed Square
Hammer
Kreg Jig
Drill
Circular Saw
Table Saw
Brad Nailer
Power Sander
Level
Drill Bit Set
General Instructions

Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!

Finishing Instructions
Preparation Instructions
Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth.

It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.

Comments

SyraChrisOrange

Thu, 06/05/2014 - 08:57

Anyone have more detailed plans on this? I was thinking of cutting it in half to make some side tables, but was hoping to have something a little more detailed to update...