Free plans to build a vintage style chest or trunk from plywood and whitewood boards! This beautiful trunk is perfect for a coffee table or a bench in the entryway. We love it throughout the home.
Our step by step plans and include detailed diagrams, shopping list and cut list.
- 4x4 (half) sheet 3/4" plywood cut into 15 3/4" wide strips x 4 feet long
- 4x4 (half) sheet 1/4" plywood or other hardboard
- 1 - 2x2 @ 8 feet long (furring strips are fine)
- 20 feet of 3 1/4" base moulding
- 10 feet of 1x6 whitewood boards or similar
- 1 - 1/4" plywood @ 36" x 20 1/4"
- 3 - 2x2 @ 20 1/4"
- 2 - 3/4" plywood 15 3/4" x 18 3/4"
- 2 - 3/4" plywood 15 3/4" x 36"
- 4 - 3 1/4" base moulding @ 36" (both ends cut NOT parallel at 45 degree bevels, short point to short point measurement)
- 4 - 3 1/4" base moulding @ 20 1/4" (both ends cut NOT parallel at 45 degree bevels, short point to short point)
- 3 - 1x6 @ 10 1/4"
- 2 - 1x6 @ 37"
- 2 - 3/4" plywood @ 10 1/4" x 10 1/4"
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
I chose to make the base like this to cut down on weight and cost in the project, and also to elevate the base from the floor. That way if there's water spilled, it won't rot the bottom out on your trunk. But by adding the 2x2s underneath, we create a system where the weight rests on top of the joints, resulting in a stronger bottom.
You can just nail and glue the base to the 2x2s - nothing special here!
Cut base moulding to fit with your miter saw set at a 45 degree bevel. I tend to cut my pieces just a tiny bit long and then trim them down to get a perfect fit. Nail on. Be careful here to select a nail size that fits your moulding thickness plus the 3/4" thickness of the plywood. Use glue too.
NOTE: You can use a wider base moulding too!
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.