This simple sturdy daybed can provide a solid sleeping space for your children or in your guest room. Featuring a classic slatted design, expect this bed to be very very sturdy, but also big and heavy.
In addition to the supplies needed for the Simple Bed, you will also need:
1 – 2×6 @ 74 1/2″ (Shown in blue above)
This cut list is in addition to the two footboards required by the simple bed (see step 1).
You will need to construct 2 footboards from the Simple Bed Plans. The only modifications you will need to make to the footboards is in the top piece, the 2×4 that finishes to top of the footboard. Cut this board at 42″ keep the front side flush with the front leg post. On the back side, keep the end edge of the 2×4 even with the end edge of the center panel of the footboard. This is shown above.
Review the plans for the Simple Bed here. You will first need to build (2) footboards, as directed in the plans for the Simple Bed.
Construct the front rail piece, as shown above. You will need
1 – 2×6 @ 74 1/2″
1 – 2×2 @ 75 3/4″
Leave a 5/8″ overhang on either end of the 2×2. Keep bottom edges flush. Attach this piece to the footboards by first screwing through the 2×2 into the corner posts (make sure you predrill first. Then predrill and screw through the outside of the legs into the end edges of the 2×6.
The bottom edge of the side rail will sit 10 1/2″ up, or even with the bottom edge of the footboard center panel.
We apologize if there was an error in this plan. Please help us out and report any errors here.