Rhyan End Table

Cut Plywood

I was just at The Home Depot the other day, and spotted these gorgeous 4×4 posts (been lusting after Crate and Barrel’s Big Sur Table for the longest time). An associate gladly cut the 4×4 to size for me, and the cuts were just perfect and only took a minute. So if your local store has a good staff, perhaps bring this cutting diagram in. Always remember that the saw blade takes up approximately 1/4″ and you cannot just mark out all the cuts and go – your pieces will not be accurately cut. My advice is to cut two strips that are 17″ wide, and then cut the strips into the 17″, 12 1/4″ and 14 1/4″ pieces. And then from the scrap cut your final back piece.

Sides

Start building the sides by attaching 2x2s to the top and bottom. You will need to build 2 of these – well, actually, go ahead and build three of these.

Side Drawer Slides

Okay, now only build two of these from the three that you build in step 2. Make sure that there are no screws sticking out here these are the drawer slide spacers.

Legs

From the two pieces with the drawer slides, add legs as shown above.

Shelf/Top

Add the top and shelf as shown above.

Back and Shelf Trim

Okay, here’s where you add that third piece you built in step 2 – to the back. Also trim out the shelves and the bottom with 2x2s as shown above.

Drawer Trim

A little piece of trim for between the drawers . . .

Drawers

You will need to build two drawers. It’s basically 1x6s surrounding the bottom plywood. You should always build your drawers to fit the opening in the end table, not to shown dimensions. Check the clearance on your drawer slides (normally 1/2") and adjust the door measurements to fit your endtable.

Drawer Slides

The blue boards in the diagram above are for attaching the drawer slides to the drawers. This drawer is designed for a standard slide requiring 1/2″ clearance on each side of the drawer. Adjust so that there is an even fit around the drawers and the drawers slide smoot