DIY Easy Build Wood Headboard Twin Size

A fun project we did with my 12 y/o niece and husband. It was fun and fairly easy. We distressed the wood by using a copper brushalong the grain and used nails to make holes. We chose rustoleum sunbleached stain hoping to create and washed out gray driftwood look. It took about an hour to put together. The next day I sanded and stained , left it dry for the rest of the day then sealed it with polycrylic spray. The hardest part was getting up 2 flights of stairs, solid wood, it was heavy. The headboard was a little tall we thought. Plans are originally for Full so as bed gets more narrow the height becomes more noticeable. I thought about cutting down the legs a bit but after we got it in the room we thought it looked fanastic. We love love love it.

Estimated Cost
Estimated Time Investment
An Hour or Two (0-2 Hours)
Finish Used
Rustoleum " Sunbleached" stain

After I finished sanding the entire headboard with about 150 grit sandpaper I starting distressing it. Hoping that the stain would sink further into crevices and give my headboard and varied look. I distressed by poking holes with a nail in random groupings. I then followed up with that copper wire brush you see. I took the brush and with some force and went horizontally across the surface following the wood grain. The put lots of grooves into the wood, again hoping that stain will sink into crevices. I chose Rustoleum "Sunbleached" stain for this headboard going with the driftwood theme. Rustoleum does not require a wood condtioner so I save myself a step here. But really I chose it because of this great color. The best way to put on stain is with a rag. The box of rags you see in the image are the absolute best. They stay together. Much stronger than a paper towel. You just throw them away when you are done. Applying stain in this manner is the best way in my opinion. Wood is porous so applying the stain with a rag forces the stain into the fibers of the wood. Using a paint brush will not achieve the same results. It also takes alot longer with a brush and then you have to wash the brush out... ugh. Staining this headboard took me 10 minutes. That's right 10 minutes. So much easier with a rag, it's like you are just wiping it down. Because I can force the stain into the wood fiber I can put the stain on a little thicker and the wood absorbs more negating the need for 2 coats. Try it and see. Of course wear gloves. Do not soak the paper towel dripping wet. As much of the towel wet as possible without dripping all over. Wipe it on with the grain paying special attention to knots in the wood. Let it dry thoroughly for a day or so. Spray with Polycrylic which also only takes a few minutes. Polycrylic recommends then lightly sanding and spraying again 3 times. We did it twice. Seems fine to me. I'm Done.
Recommended Skill Level