Pentagon Cooler table

Submitted by Anonymous (not verified) on Fri, 03/25/2016 - 09:05

This table was made with already turned legs purchased at HD, one 4 x 8 sheet of oak plywood cut into two 4 x 4 sheets, pine for the cooler supports and edged with 1 x 3 oak routed with an ogee detail. Table supports were attached to the legs using pocket holes. Legs and supports were attached to the table bottom using pocket holes. The opening for the cooler was cut by plunging a circular saw from the top.

Estimated Cost
cost ~ 175
Estimated Time Investment
Day Project (6-9 Hours)
Type of Wood
Finish Used
Minwax Early American stain
Minwax Polycrylic Polyurethane
Recommended Skill Level

Free Plans Made Possible By Our Sponsors