Scrapes to Frame

Simple project with 2 pcs of 1x6 @ 20" 

I riped them down to 8 pcs @ 1 1/2" pcs and used dado blades to cut out so that half of them would cap one side of. Once capped, I cut them at 45 degrees to the size of the puzzle. I used mode podge to glue the puzzle together. I cut a scrap pc of 1/8" mdf to 1/2" over the size of the puzzle. I then router ed a slot for the puzzle and mdf to slide into, glue and a few staples...... all done! 

Estimated Cost
Just a couple of bucks
Estimated Time Investment
An Hour or Two (0-2 Hours)
Type of Wood
Pine
Finish Used
I burned it with the torch and then coated it with tung oil
Recommended Skill Level
Starter Project

Free Plans Made Possible By Our Sponsors