Tiny bathroom wall system

Submitted by RebeccaGB on Sun, 10/12/2014 - 17:17

This project was not as simple as I expected! For this little bathroom, the mirror is offset, leaving lots of wasted space above the sink so my friend asked me to build some storage. I thought this would be a great solution that could maybe move with her later on, and it turned out pretty well. My two problems were 1- I had to cut the steel pipe to fit the space and 2- my hardware store did not sell S-hooks that would fit over the steel bar.  I used 1/2 in steel bar, so I cut it with my Dremel rotary cutting wheel. It was a bit slow but it worked and once I cut halfway, I could just bend the pipe to break it at the cut. The two cut ends are not threaded so I had them each end into one side of a 3/4 T fitting. For the S-hooks, I bought ones that were about the right size, then bent them open wider using a large screwdriver and a crow bar as a wedge. Two large screwdrivers might work as well. Instead of the straps, I used a thin steel bar, drilled through one side. I am happy with how it turned out, took about an afternoon not including all the time thinking it out! Finished with butcher block oil.

Estimated Cost
$35
Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
Butcher block oil
Recommended Skill Level
Intermediate