Truss Beam Coffee Table

Submitted by mlatanzi on Fri, 12/30/2016 - 08:42

Slightly modified version replacing the "X" with a Truss design on the ends. The table top uses a 2x8 in the center and 2x6 boards for the rest. This is because when you rip the edges off the 2x6's for a nice gap free table top the total width of the top is too small so the 2x8 in the center re-gains the lost width. Finished with Minwax Expresso and Spar Urethane Ultimate!

Built from Plan(s)
Estimated Cost
$75
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Minwax Expresso and Spar Urethane Ultimate
Recommended Skill Level
Intermediate