Workbench Plans by Ana

Submitted by chadbadow on Sat, 03/06/2021 - 14:10

Thank you for the plans for this workbench. I’m new to this and they worked like a charm. The scraps I had, fit perfectly for upper and lower shelf backboards. In doing so, I did square up and nail the full sheet of plywood to the table. Then cut with a circular saw with guidance from a fence. Doing this on length and width gave me perfect backboards for the top and bottom levels. The only scrap was the 2x4’s and they were minimal. Thanks again. It turned out perfect!

Free Plans Made Possible By Our Sponsors