3" Think End Table

| Print this plan

About Project

Saw the Griffen Line of furniture at pottery barn and liked it not the price, so here is piece 1 the end table, planning on making the coffee table, and dining table next. :0)

24H x 27L x 22W


Shopping List

2 - 2x6x8
2 - 2x4x8

Common Materials
Cut List

8 - 2 x 6 @ 27" (Table Top)
4 - 2 x 4 @21" (legs)
2 - 2 x 2 @ 17 (Long Rails (I cut down 2x4 to 2x2)
2 - 2 x 2 @16 (side rail)
2 - 2x4 @16" (Bottom cross supports)

Tape Measure
Speed Square
Safety Glasses
Hearing Protection
Kreg Jig
Circular Saw
Table Saw
Power Sander
Drill Bit Set
General Instructions

Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!

Finishing Instructions
Preparation Instructions
Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth.

It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.



Sun, 12/21/2014 - 17:28

Hello. Looking for complete plans to build this table. Please and ty.