Corner Hutch Plans for the Twin Storage Beds

Submitted by Ana White on Tue, 07/09/2019 - 11:07
Difficulty
Intermediate
| Print this plan

Shared room?  What about adding a corner hutch between beds?  It acts as a headboard for both beds and contain storage.  We've got you covered with the free plans below.

We also have plans for twin storage or captains beds here.

green twin beds with corner unit

 

OVERALL DIMENSIONS

Are shown above.  Remember that a twin bed runs about 75" long to fit the space.

 

ROOM MEASUREMENTS Ready to build it?  Go measure your room and make sure you've got 116" of space in two directions in a corner.  I could actually see a setup like this in a family room.  And somewhere, someone's gonna put a TV on top and use the corner unit as a footboard instead of a headboard.  I won't tell on you.

Dimensions
dimensions diagram for corner unit for beds
Dimensions for corner unit shown in diagram. Consider twin beds runs about 75″ long to fit the space

Preparation

Shopping List
  • 7 – 2×2, 8′ Long, Furring Strips
  • 2 – 32″ High x 40 1/2″ Long (or longer) Wainscoting Panels OR 1 sheet of 1/4″ plywood or MDF
  • 2 – 1×8 Boards, 8′ Length (Pine is cheapest)
  • 1 – sheet of 3/4″ plywood or MDF
  • Edge Banding (if you are using plywood and staining the bed)
  • Wood Filler
  • Wood Glue
Common Materials
120 grit sandpaper
primer
wood conditioner
paint
paint brush
Cut List

CUT LIST FOR THE BOX

  • 4 – 2×2 @ 40 1/4″ (Tops and Bottoms Box Ends)
  • 4 – 2×2 @ 29″ (Legs for the Box Ends)
  • 6 – 2×2 @ 37 1/4″ (Supports)
  • 2 – 32″ High Wainscoting @ 40 1/2″ (Panels)

 

CUT LIST FOR THE TOP UNIT

  • 1 – 1×8 @ 40 1/2″ (End)
  • 2 – 1×8 @ 39 3/4″ (Long Dividers)
  • 1 – 1×8 @ 14 1/2″ (Short Divider)
  • 1 – 1×8 @ 24 1/2″ (Final Divider)
  • 1 -1×2 @ 24 1/2″ (Cleat for Support Lid, 1st one installed)
  • 1 – 1×2 @ 23 3/4″ (Cleat for Support Lid, 2nd one installed)
Tools
Tape Measure
Speed Square
Pencil
Safety Glasses
Hearing Protection
Drill
Circular Saw
Brad Nailer
Level
General Instructions

Work on a clean level surface with straight boards and check for square after each step. Always predrill and countersink every screw. If you are working with MDF, use Drywall screws and be sure to predrill the entire length of your screw. Use glue. Be safe and have fun.

Instructions

Step 1

BOX ENDS Build the box ends as shown above using 2″ screws and glue.

Step 2

SUPPORTS FOR THE BOX Add the box supports using 2″ screws and DO NOT GLUE. Make sure your project is square at this point. To relocate the bed, you can simply unscrew, disassemble, and then reassemble.

Step 3

WAINSCOTING Measure and cut your wainscoting to fit one side of the box. Then add the second piece. Attach with 1 1/4″ screws and DO NOT GLUE on all four edges. You want these pieces removeable so that you can move it in and out of a room. NOTE: If your doorways are larger than 32″ you can move this unit without disassembling, but just in case you move to a different home, I would still not glue this step.

Step 4

DIVIDERS Use 2″ screws and glue to build your dividers as shown above. Then add the 1×2 cleat (shown above in white) with 1 1/4″ screws and glue.

Step 5

Step 6

FINAL CLEAT Add the final cleat, using 1 1/4″ screws and glue. Then also attach from the outside of the project using 2″ screws and glue.

Step 7

BOTTOM Cut your bottom plywood and attach it to the bottom of your unit (cleats are on the top) as shown above. Use 2″ screws and glue. This is just like attaching a back to a bookcase.

Step 8

TOP Cut your top, as directed above. Attach only the white piece to the top of your project. The pink piece is removable for storage (might be scary in a teens room

Step 9

ASSEMBLY Attach from underneath the top unit to the base unit using 2″ screws. Don’t glue so that removal is easy to do. You may also wish at this point to drill holes in certain point to create a “Smart” storage unit. You could hide cords in the “secret compartment” and keep cell phone chargers, laptop cords, or cords for media units tucked away neatly.

Finishing Instructions
Preparation Instructions
You can add trim to make the piece nicer, but just remember that the base will most likely be covered by pillows from the beds. Use wood filler to fill all holes. If you are staining, iron on edge banding to any exposed plywood edges. Sand starting with a coarse grade sandpaper and work your way up to fine. Prime or add wood conditioner (if desired for staining pine). Paint or stain. Seal if necessary.

Comments

kazey

Sun, 05/05/2013 - 07:34

This one is truly helpful. This will help save space in kids bedroom. There are also spaces where you can place books, and other things. Thank you for this tutorials. - JustFab

Candacer28

Fri, 05/23/2014 - 08:32

Hi. My name is Candace and I love this project. I am a soon to be new step mom to 2girls ages 5 and 7. I saw this bed at pottery barn and feel in love but I knew paying $3000 was not going to happen. So I started searching online and I found this site. I would love to have the beds, corner unit and the hutch but I know I can not build this. I understand that it's easy but I am city girl and I wouldn't even know where to begin!!!!!!! Are there any builders in NC. Raleigh Durham Cary area that you know of? Thanks so much

Shenagh

Fri, 06/10/2016 - 01:16

Hiya i love this idea but what plans do you use for the beds cant seem to find it??

trishapro90

Fri, 07/29/2016 - 11:36

I'll start by saying I LOVEE THESE PLANS!!!! I started about a year ago, when my husband an i discovered the loft bed with the desk an shelfs underneath... that was the first thing we have ever built, an it came out AWESOME!!! However, now we would like to build the storage unit/ twin bed collection with the open spaces below the bed for more storage an the corner unit.... The problem is, i've searched all over the website and i still can't find the orginial plans for the twin beds, and the corner shelf... I printed the 20 pages out of the plan thinking it was the corner shelf and both of the twin beds... An it was just the corner shelf... COULD SOMEONE PLEASE HELP ME with the plans for the beds??? thank you so much..

go_eli

Thu, 04/05/2018 - 16:11

Hi, we are really enjoying your website! Your creations are beautiful! I particularly love this bed with corner hutch. Where can I can find the plans for the exact one in the picture (the green bed with the 3 cubbies in the bottom)? I seem to only be able to find the plans for the bed with two cubbies in the bottom and then the other two cubbies at the the end of the bed. I prefer the look of this green bed. I'd really appreciate it if you'd let me know if the plans for this exact bed are available.

Cheers!