Create a luxurious headboard for your bed with these simple plans. Special thanks to Amy for sharing her photo. Amy also built the bed (it's a queen size) from her own plan.
1 – 3/4 MDF or plywood (can be low grade, but make sure the plywood is straight and not damaged)
A) 1 – 3/4″ Plywood or MDF @ 76 1/2″ x 40” (Back, you can use builder’s grade plywood)
Store bought moulding, cut to fit the opening, covering the 1×3 bottom layer trim.
1/2″ plywood, cut to fit the opening (approximately 35″ x 71 1/2″)
Please note that the actual width will be 78″ and not 84″, as shown in dimension diagram(to fit a standard king, 78″ wide). The cut list will reflect this change. To make a queen sized, simply subtract 18″ from all horizontal cuts, leaving all vertical cuts the same. (queen sized mattress measures 60″ x 80″)
Fabric Insert. Measure and cut the panel insert, shown in green above. Your panel should measure approximately 35″ high x 71 1/2″ long. This is correct, and the dimensions given above for the length are 6″ too long.
Dry fit your panel. You may wish to leave some room around the panel to give allowance for foam backing and fabric. When you are satisfied with the fit of the panel, cover with foam, batting and fabric, stapling on the back. Using the 1″ screws, screw from the back of the headboard into the center panel, holding the panel in place. You will want screws in each of the corners, and in the center.
We apologize if there was an error in this plan. Please help us out and report any errors here.