Free simple easy to build do it yourself plans to build a DIY porch swing or bench. Features extra wide and deep seat, ideal for napping or lounging, perfect for standard cushions. Plans call for off the shelf dimensional lumber, mostly 2x4s, and standard screw joints. Painted a pretty blue turquoise color, this porch swing is a breeze to build!
6 - 1x6 @ 6 feet long
5 - 2x4 @ 8 feet long
4 - Eye Bolts with Nuts, 3" long
Chains or rope, we used 200 pound weight limit (for four ropes, capacity of 800 pounds)
Hardware to hang to rafters/tree
5 - 2x4 @ 21" (Support Joists)
2 - 2x4 @ 72" (Front/Back Aprons)
2 - 2x4 @ 11 1/4" (Arm Fronts)
2 - 2x4 @ 25 1/2" (Arm Rests)
5 - 2x4 @ 18 1/4" (Back Supports)
6 - 1x6 @ 72" (slats)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Build the seat frame as shown above, using either pocket holes set for 1 1/2" stock and 2 1/2" screws, or wood glue and 2 1/2" screws predrilled and countersunk.
To the back of the seat frame, attach the back supports, 2 1/2" screws and wood glue.
Now the arm rest supports - same thing, 2 1/2" screws and wood glue.
Armrests go on top - check and adjust for square.
And finally the seat slats - start at the front, leave 1/2" gaps, and nail and glue down with 2" finish nails.
Now it's time to hang it! We hung ours on an existing playground swing set, but your situation may likely vary from mine. Here is a good article on proper hanging of swings.
On this swing, you will want to hang from the side aprons of the seat frame - that's where the majority of your weight will be. Also, I hung ours at a very slight (approximately 5 degree) back angle, to increase the comfort level.
DISCLAIMER: Build, hang and use at your own risk - We are not liable for personal injury, loss or death from use of swing. See our full disclaimer at bottom of all pages.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.