Use 1x board to build a leaning ladder wall bookshelf! Easy plans by ANA-WHITE.com
SHOPPING LIST FOR 1 BOOKSHELF
4 - 1x3 @ 8 feet long
1 - 1x6 @ 16" long
1 - 1x8 @ 4 feet long
1 - 1x10 @ 16" long
1 - 1x12 @ 16" long
CUT LIST FOR ONE BOOKSHELF
2 - 1x3 @ 76-1/4" - both ends cut at 5 degrees, parallel, long point to short point measurement
1 - 1x3 @ 17-1/4" - back support
5 - 1x3 @ 15-3/4"
1 - 1x6 @ 15-3/4"
3 - 1x8 @ 15-3/4"
1 - 1x10 @ 15-3/4"
1 - 1x12 @ 15-3/4"
2 - 1x3 @ 6-1/4"
2 - 1x3 @ 8"
2 - 1x3 @ 10"
2 - 1x3 @ 12"
2 - 1x3 @ 15-3/4"
It is important to cut the backs and shelves to the same length. To do this quickly and accurately, consider a stop block on your saw, spaced out the shelf width from the saw blade, and clamped or screwed down (depending on your set up). Some saw stands have this functionality built in.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Add sides as you did the back.
For a stronger shelf, you can also pocket hole the sides on from underneath.
I cut the corners on my sides at 22-1/2" degrees (I choose this number because it is a setpoint on my saw, the exact degree can differ). To do this quickly, I made a small mark on my saw with a pencil, when I had the board in the position I wanted to cut it at. Then after cutting, I just took the next side, lined it up with my marks, and cut. No measuring needed.
To get the bottom shelf in place, I first positioned the frame against a wall, making sure legs were 9-1/2" out from the wall. I then measured up 9-1/2" and added the shelf with clamps and used a level to ensure it was level. Then I screwed it on with 1-1/4" screws (you can use pocket hole screws here).
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
We apologize if there was an error in this plan. Please help us out and report any errors here.