As you have requested, here are plans for a toy washing machine, just in time for the Holidays. If you have been working on other projects, save your scraps. You just need a few scraps to build this super cute gift idea! Special thanks to our readers for the photos.
1 - 1x12 @ 6 feet
1 - 1x3 @ 2 feet
1 - 1x4 @ 2 feet
1/4″ Plywood @ 17 1/4″ x 13 3/4″
Plexiglass cut at 7 1/4″ circle (You can get plexiglass in 8×10 sheets for photo frames at Lowes, Home Depot, Joanns and other craft stores for less than $1)
You will also need knobs for the door and the controls.
A) 2 – 1×12 @ 17 1/4″ (Sides)
B) 1 – 1×12 @ 12 1/4″ (Bottom Shelf)
C) 1 – 1×3 @ 12 1/4″ (Footer)
D) 1 – 1×4 @ 12 1/4″ (Header for the Controls)
E) 1 – 1×12 @ 12 1/4″ (Front, cut out hole in center at 7″ diameter)
F) 1/4″ Plywood @ 17 1/4″ x 13 3/4″ (Back)
G) 1 – 1×12 @ 13 3/4″ (Top)
H) 1 1×12 @ 9″ (Door, cut out door shape and the center for the window)
Plexiglass cut at 7 1/4″ circle
Start by cutting out all your boards, as listed above. Always use glue and 2″ nails, unless otherwise instructed.
Nail through the outsides of A, the sides, into the end edges of B, the Bottom Shelf, as shown above.
Nail the footer, C, in place as shown above. Make sure you nail through the sides, A, and the bottom, B.
Nail through the sides of A into the header, D, as shown above. Keep top and outside edges flush.
Add the front, E, as shown above. Use the 2″ nails to nail through the sides, A,into the edges of E, but use 1 1/4″ nails to nail through the back of E into the back of the header, D.
Cut out the shape above, the circle part being a 7 1/2″ diameter, and the trim around the window 1″ wide. From the back, predrill and use short screws to screw the plexiglass to the back side of the door. Attach with hinges when the finish is complete.
Attach knobs and handles as desired. Don’t forget a magnetic clasp on the door!