DIY Doll pram or stroller made from wood scraps.
4 - 5" rounds or store bought wheels and bolts
1 - sheet of 1/2" plywood @ 24" x 24" (available in project panel section of hardware store)
1 - 1x10 @ 36" long
1 - 1x2 @ 36" long
1 - 1" dowel @ 7-3/4" long
2 - 1/2" plywood @ 19-1/4" x 12" (sides of pram - will be cut out with jigsaw)
1 - 1x10 @ 9-3/4" - long point measurement, one end cut at 20 degrees off square (front of pram)
1 - 1x10 @ 5" - long point measurement, one end cut at 20 degrees off square (back of pram)
1 - 1x10 @ 13-3/8" - long point to long point measurement, both ends cut at 20 degrees off square, ends are NOT parallel (bottom of pram)
5" rounds or store bought wheels
2 - 1x2 @ 16" long
1 - 1" dowel cut at 7-3/4" long
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Install wheels to sides through predrilled holes. For more details on Jaime's wheels and how she installed them, please go here.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
We apologize if there was an error in this plan. Please help us out and report any errors here.