This has probably been done before but here it is for consideration by my fellow woodworkers. If you're anything like me I get pretty impatient waiting for wood glue to work its way out of the tube. So using some scrap wood, I drilled 1.5 inch holes in a small 1x4 board and elevated it about 3 inches. A small board under the glue tubes catches any unwanted drips. Makes a perfect caddy for my glue tubes and no more waiting for my glue. Its always ready to go!
Estimated Cost
1.00
Finish Used
No finish
Recommended Skill Level
Starter Project
Comments
Tsu Dho Nimh
Wed, 06/03/2015 - 06:25
That's brilliant!
Nice way to keep them collected AND ready to go.
Could do the same for condiments, maybe.