Build a basement indoor playground with monkey bars. Playhouses can be used as beds or bunk beds. Free plans by Ana-White.com
2x4s (we started with 24 and added a few more)
1x4s (we started with 10)
1x6s (we started with 18 - plywood can also be used for decking/floors and may be cheaper)
2x8s (we used 2-16 footers and 4 - 8 footers) - For greater spans you may need a 2x10 or 2x12 or to cross brace
For the little peaked roofs, you'll need 6 1x3s
1/2" thick plywood (we used six total sheets)
We screwed everything together with 2" and 3" self tapping screws with torque heads (saved a ton of work to not have to predrill)
We used 1" pipe (can also use 1" hardwood dowels) for the monkey bars, spaced 12" apart
Recommend cutting to fit
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Since our walls are nine feet tall, we just took eight foot long 2x4s and screwed an 8 foot long 2x8 to the top and an 8 foot long 2x4 near the center (see diagram) with 3" wood screws - no cutting required. We made four of these. If you have eight foot ceilings, you can make all the legs stud length (92-5/8") and avoid cutting. One precaution is to check the length of your boards - sometimes they can be off, especially if they are not studs.
For window and door trim, we Kreg Jigged frames first out of 1x3 boards, and then attached them from the inside to the plywood. You might need 1-1/2" or 1-3/4" screws to prevent the screws from poking through.
I recommend skipping to step 9 - putting the floor in - because once you tie the two playhouse together you won't be able to climb behind it and screw the floor framing down.
Since we wanted monkey bars, we cut the monkey bar doorway header out and then attached another 2x8 to create a channel for the monkey bars. We then drilled 1" holes for the monkey bars, and spaced them 12" apart. You won't need a monkey bar super close to the playhouse - we could easily have gotten away without the first and last bars. Also to keep the monkey bars in place and not twist, we added a screw through the top of the wood into the top side of the pipe.
For siding, we pulled scraps from our shop - everything from pine boards to plywood to cedar fence pickets. I had originally wanted to put the boards on crooked, like kids made the playhouse, but it just didn't work out that way. Maybe you'll do yours that way.
If you aren't flush against the back wall, you might want to add some boards back there too. Of course, we don't leave our baby unattended, ever, on this.
For the bridge, we attached 2x4s between the two playhouses. If you are not putting plywood under the bridge or longer spans, you may need a wider width board to support the bridge (2x6 or 2x8). We also added a ladder rung for climbing up to the upper level and preventing kids from falling through at the end of the bridge.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.