Built Patrick's Router table and added a rockler table, fence, and lift to finish off.
Built from Plan(s)
Estimated Cost
~$90 in lumber and hardware + ~$460 for table top, fence, and lift + $170 for bosch 1617evs router
Estimated Time Investment
Day Project (6-9 Hours)
Type of Wood
Pine, solid and ply
Finish Used
raw, probably sand and spray some poly on it in the near future.
Recommended Skill Level
Intermediate
Comments
Patrick Hosey (not verified)
Fri, 11/02/2012 - 09:10
yes!
Yes! Enjoy. It'll be the most valuable tool in your shop trust me.
patrickhosey
Sat, 11/03/2012 - 19:28
Router set up
Here's a tip for that 1617 router. Try putting a bandaid over the on/off switch. That thing will get gummed up if left uncovered. It's annoying.
Ronald629
Sun, 03/22/2015 - 05:26
Router Table Lifts
Well, you can read this review http://routertablereviews.com/router-table-lifts-kreg-prs3000-vs-jessem… as well.
Ronald629
Thu, 09/10/2015 - 07:15
Yonico router tables
You can check this http://oydeals.com/yonico-21052-ultimate-heavy-duty-router-table-workstation-with-sliding-top/ as well.
jimssolidwoodp…
Sun, 03/05/2017 - 21:13
Patrick router table question
My question for Patrick is when he built the top section for 2 small drawers and middle section for the router access..
Did Patrick put on top a 3/4" pc of plywood then the router table top.
Can l attach my router table top to the top pc if 3/4"plywood then my table top is 1 3/4" thick that it would be to thick could you email to let me know please.
Jim