Farmhouse Table

Submitted by sbowes1 on Sun, 02/26/2012 - 23:05

This was our first woodworking project. I was not that hard to put together.

I made a couple of changes to the design. I used 4x4 for the legs. I also change up the board that were used ontop. I have a step by step on my blog.

The almost the same as the table. Check out the changes and the cut list here: http://www.domesticated-engineer.com/1/post/2012/05/bench-for-farmhouse…

Built from Plan(s)
Estimated Cost
$200
Estimated Time Investment
Week Long Project (20 Hours or More)
Type of Wood
Pine
Finish Used
#41 Walnut Wood Stain
Satinthane Polyurethane
Recommended Skill Level
Beginner

Comments

Guest (not verified)

Tue, 02/28/2012 - 05:13

Can you post a link to your blog with the instructions? Did you make your table a little shorter than the original plans?