Tryde console table in oak

Submitted by rherlein on Mon, 11/03/2014 - 06:04

I altered the plan to make the table work as an end table.  Due to the table being made of oak, I was not able to  add the leg bacing at the bottom.  I am going to purchase a pocket hole jig to try to attach the bracing that way.  Both tables have 21 inch legs, one table I left the original length, the other I shortened by 12 inches to better fit in the corner of the room.

Built from Plan(s)
Estimated Cost
Due to using oak, I have about $150 invested between the 2 tables
Estimated Time Investment
Day Project (6-9 Hours)
Type of Wood
Oak
Finish Used
Minwax Polyshades
Recommended Skill Level
Beginner

Free Plans Made Possible By Our Sponsors