Mountain Wall Hooks

Submitted by Ana White on Fri, 11/23/2018 - 10:00
Difficulty
Beginner
| Print this plan

Easy DIY tutorial to make your own mountain range wall hooks.  Free tutorial by ANA-WHITE.com

Add a rustic and functional touch to a room with these mountain range wall pegs!  All you'll need is a small piece of scrap wood and dowels or hooks to create this easy DIY project!

As part of Jaime Costiglio and I's annual Handbuilt Holiday series -

Where we bring you a new free gift plan every Friday in the weeks leading up to Christmas, we are so excited to share with you this brand new DIY project!

It's fun, it's fast, it's easy, it's inexpensive!  

Check out Jaime Costiglio's Build Post - with lots more photos and building tips right here!

Ready to build it? The free plans inspired by Crate and Kids Mountain Range Hooks are below. 

Enjoy! Ana

 

 

CLICK HERE FOR MORE PHOTOS AND BUILD POST AT JAIME COSTIGLIO.COM

 

 

 

Dimensions
18" wide x 4-3/4" tall x 2-3/4" deep

Preparation

Shopping List

1 - 3/4" plywood scrap @ 4-3/4" x 18"

1 - 1" diameter dowel @10" long (can also use 3/4" dowel)

Drill bit to match the dowel diamenter, recommend forstner bit

3 - wood screws at least 1-1/4" long (can use pocket hole screws)

picture hanging kit 

Common Materials
Tools
Tape Measure
Speed Square
Safety Glasses
Hearing Protection
Drill
Circular Saw
Jigsaw
Power Sander
Drill Bit Set

Instructions

Step 1

Cut the 3/4" plywood piece to size using the circular saw.  Measure and mark the points on the top and bottom of the plywood.  Draw lines between the points as shown in the diagram.  Use a jigsaw to cut out the mountain shape using the lines as guides.

Step 2

Mark the location of the dowels.  Drill a small pilot hole all the way through the plywood.  Then use the forstner bit to drill a hole the same diameter 3/8" into the plywood, with the drill bit centered on the small pilot hole.

Step 3

Cut the dowels (preferably with a compound miter saw but you can also cut with a jigsaw or circular saw - just clamp to a table first.  

Apply glue inside the forstner bit hole.  Insert the dowels.  Flip over and use the 2" self tapping screws to secure the dowels through the small pilot hole.

Help Improve This Plan

We apologize if there was an error in this plan. Please help us out and report any errors here.