Build your own toddler solid wood bed inspired by Pottery Barn Kids Catalina Toddler Bed! This do it yourself free plan is easy to build and can save you hundreds off the retail!
2 - 2x2 @ 8 feet long
3 - 1x6 @ 27 1/2"
2 - 2x2 @ 24"
1 - Beadboard Paneling @ 23" high x 30 1/2" wide cut to fit
2 - 2x2 @ 10"
2 - 1x6 @ 50 3/4"
4 - 1x2 @ 11"
4 - 1x2 @ 24 1/2"
2 - 2x2 @ 51 1/2"
15 - 1x3 @ 27 1/2"
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
With one of the 1x6 boards, cut out the header shape as shown above. I recommend using a piece of legal sized paper to create a pattern, and trace that pattern on both sides so both are identical. Use a jigsaw and carefully cut. Follow by sanding until you are satisfied.
With the header cut, go ahead and drill Kreg Jig pocket holes on ends and attach to legs as shown in diagram.
Trace the shape of the headboard on to your beadboard paneling. Cut shape out slightly smaller so your edges are not visible from front. Tack on with 1" finish nails and wood glue.
Build your footboard as shown above.
Guardrails should be a piece of cake. Just make sure you round the front corner. For stronger guardrail attachment, use 1/4" bolts, 2" long, with nuts and washers through predrilled 1/4" bolt holes.
Now the cleats. Measure and mark the insides of your siderails 2" down. Attach cleats with 2" screws and wood glue.
TIP: Predrill holes with your countersink bit every 6-8" with the cleats on your work surface. Then screw in place.
Now add the slats! I found that closer slat spacing is better for crib mattresses because the mattresses themselves are so flimsy. Plus, a little foot could slip through wider spacing.
Using 1x3 boards - which are about $1.50 each - you will only need 5 total 1x3s. The difference between wider spaced slats and narrower spaced slats is about the cost of a fancy cup of coffee.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.