On the right hand side of the page, almost at the bottom, there is a section:
Members of Our Site
Under that heading, select the "Your Account" option.
That will take you to your account, and click on the "Track"Tab, and listed will be forums you have posted to and contributed to.
I just bought my saw a month ago and I have been having trouble with accuracy! At first I assumed it was user error, but then I noticed that my laser is always off of my lines. even ones I draw with an accurate square. I also noticed that my 0degree is not quite 0 degree Do you have any suggestions? I was hoping to fix this myself since I do not have a store close to me and if it happens again, I want to know what I am doing?
Thanks
Gina
Im trying to comment to ask a question to this post but the site seems to be not letting me. I wanted to ask how the open end of the tile backsplash was treated on the wall by the bar top. Was some type of end cap used? Or was it just left raw cut on the open edge?
Juanita_r
Fri, 04/18/2014 - 06:00
Its in the Your Account section
On the right hand side of the page, almost at the bottom, there is a section:
Members of Our Site
Under that heading, select the "Your Account" option.
That will take you to your account, and click on the "Track"Tab, and listed will be forums you have posted to and contributed to.
Hope that helps
gvandy
Fri, 04/18/2014 - 17:17
ryobi 10 inch sliding mitre saw
I just bought my saw a month ago and I have been having trouble with accuracy! At first I assumed it was user error, but then I noticed that my laser is always off of my lines. even ones I draw with an accurate square. I also noticed that my 0degree is not quite 0 degree Do you have any suggestions? I was hoping to fix this myself since I do not have a store close to me and if it happens again, I want to know what I am doing?
Thanks
Gina
jwkw07
Sat, 04/19/2014 - 23:10
ryobi
does your saw cut the line you made? if so the laser is off
lplatt12
Thu, 01/15/2015 - 07:28
Mosaic Tile backsplash
Im trying to comment to ask a question to this post but the site seems to be not letting me. I wanted to ask how the open end of the tile backsplash was treated on the wall by the bar top. Was some type of end cap used? Or was it just left raw cut on the open edge?