Rustic Farmhouse Headboard (Twin)

Submitted by Ana White on Tue, 08/06/2019 - 13:59
Difficulty
Intermediate
| Print this plan

A beautiful simple headboard reminiscent of an old barn door. Our free step by step plans are perfect for the beginning woodworker.

You can also build the matching storage bed frame with our free plans.

Collections
rustic farmhouse headboard with cross detailing

Reader submitted photo by  ANGELADROSE 

We love everything about this rustic farmhouse headboard.  It's stunningly beautiful on it's own.

Or pair it with our matching diy storage bed frame -

diy storage bed frame

Photo SUBMITTED BY KILE529 

Dimensions
rustic farmhouse headboard dimensions diagram
Dimensions are shown above.

Preparation

Shopping List

6 - 1x4 Boards @ 8 feet long

2 - 1x2 Boards @ 8 feet long

3 - 1x3 Boards @ 8 feet long

Common Materials
1 1/4 inch finish nails
2 inch finish nails
120 grit sandpaper
primer
wood conditioner
paint
paint brush
Cut List
  • 12 - 1x4 @ 31" (Panel Boards)
  • 2 - 1x2 @ 49 1/2" (Side Legs)
  • 2 - 1x3 @ 49 1/2" (Front Legs)
  • 2 - 1x3 @ 38 1/2" (Back Supports)
  • 2 - 1x4 @ 38 1/2" (Front Trim)
  • 1 - 1x4 @ 26" (Center Trim)
  • 1 - 1x3 @ 44" (Top Trim)
  • 1 - 1x4 @ 45" (Top Trim)
  • 2 - 1x4 @ 30" (Cross Bracing, ends cut 30 Degrees off square, parallel)
Tools
Tape Measure
Speed Square
Pencil
Safety Glasses
Hearing Protection
Drill
Miter Saw
Brad Nailer
Power Sander
Drill Bit Set

Instructions

Step 1

Shown above is a back view.  Use a finish or brad nailer and glue to secure the back support boards to the panel boards.  Please note that sometimes boards are not exactly the correct width – you could purchase “bad” boards.  Measure your panel boards to make sure they are 3 ½” wide.  If they are not, you should cut your back support boards to fit the panel, and not to the measurement I have given above.  Adjust for square.

Step 2

Attach the 1x2 leg sides to the panel as shown in the diagram. 

Step 3

Attach the 1x3 legs to the front, as shown in the diagram.  As you nail to the 1x2 leg, keep the seam as tight and flush as possible making the legs appear as a solid piece.

Step 4

Use 2” nails an glue to attach the front trim to the panel boards, keeping outside edges flush.

Step 5

Mark the headboard as shown in the diagram.  Use glue and 1 ¼” finish nails to attach the center trim to the panel.

Step 6

As shown in the diagram, attach the 1x3 top trim to the top of the headboard. 

Step 7

Attach the 1x4 top trim to the 1x3 top trim, with a ½” overhang on all edges.

Step 8

This step looks more difficult that it is.  Cut from a 1x4 two boards with both ends at 30 degree angles (off square), ends are parallel to each other.  The board will measure 30” long, from the short point to the long point.  Then on the top side, measure 2 ½” in from the short point and cut off at a 90 degree angle.  Fasten in place with 1 ¼” nails and glue.

Project Type
Room

Comments

Brandy Ellen P… (not verified)

Wed, 08/04/2010 - 08:25

yep! that is EXACTLY the bed (in a KING size) that I want for our new farmhouse!

PRETTY PLEASE, Ana??????

Megan (not verified)

Wed, 08/04/2010 - 08:46

this is it!!! I have been looking and looking and debating and debating, some more. And it all just came to a stop! THIS IS IT! I love it!!!!!! (in a king size...) THANK YOU!!!!

Mom (not verified)

Wed, 08/04/2010 - 10:09

Just when I think there couldn't possibly be any more furniture that I "need" to make, this beautiful piece appears. Love it! Thanks so much.

Rachel (not verified)

Wed, 08/04/2010 - 10:34

Ooh!! Cute!! I tried to find a suggestion box on your site...but couldn't find one. :P Maybe on the new site? :) I love all your furniture so much! I am really needing to build a couple of pieces that you do not have plans for unfortunately. :P I need a bench for a vanity seat and I would LOVE to build a hope chest for the foot of my bed. Any suggestions?

*MICHELLE CAUDLE* (not verified)

Wed, 08/04/2010 - 14:00

Wow, it's amazing how easy it looks to build this bed when you break it down and I'm excited at how cheap it should be to build!!

Stephanie (not verified)

Wed, 08/04/2010 - 14:21

You just made my life so much harder ... now I don't know if I want the farmhouse canopy bed (which I had pretty much decided on) or the brookstone storage bed! Could you pretty please make plans for the bed in queen size?

Momma Button (not verified)

Wed, 08/04/2010 - 14:46

I'm agreeing totally with Stephanie. I don't know which to make, this one or the farmhouse bed (queen size please.) Decisions decisions.....

Jen (not verified)

Thu, 08/05/2010 - 11:14

Ana, I LOVE YOUR BLOG! Thank you!! You've got me so inspired. You find time to build *and* be a mom. I'd love to see this plan in a KING size bed! I've lusted after the farmhouse bed, but really want the storage like the Stratton bed. This is perfect. King size please!

The Family Jacob (not verified)

Thu, 08/05/2010 - 18:59

Ana, Do you have plans for the lower section of the bed? Our current bed is not long for this world and is not what I really wanted anyway. I would love it if you have plans for the bed and like so many others would love it in a king size!!!