Featuring five shelves and five drawers, this bookshelf/dresser isn't just a smart storage solution. It's also a top bunk support system.
For a good tutorial on putting a drawer together and the recommended slides, please see this wood kitchen cabinet organizer drawer plan.
2 - 1x12 @ 8 feet long
4 - 1x12 @ 46 5/8"
This plan is highly dependant on widths of boards. Make sure that your 1x12s measure 11 1/2" wide (if you have 1x12s ripped from plywood, rip them at 11 1/2" wide) or you will need to adjust cuts as you go. Also, the drawer fronts are for 1x8s that measure 7 1/4" wide, so measure yours and adjust accordingly.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it.
This plans uses pocket holes. Before joining any boards, identify all necessary pocket holes on each and every board and drill all pocket holes.
This cabinet is designed for drawers with a 1x8 face. Measure the width of you 1x8s. With a 7 1/4" wide 1x8, you will be able to have drawer faces with 1/8" gaps around all sides. Attach the 2x2 drawer dividers as shown above. These are not supportive (no weight will be resting on them) so you can use 2" finish nails and glue.
Now it's time to build the drawer boxes. Each box needs to be 1" less in width than the opening for the drawer (for standard drawer slides). Measure first your drawer opening, and then build your drawer to fit.
Attach 1/4" plywood to the bottoms of the drawers. Use the drawer slides that are bottom/side mount so that the weight of the drawer is resting directly on the drawer slide (see below link).
Attach the drawer slide to the drawer boxes and insert the drawer box. Remember, the drawer will get a face, so the drawer box needs to be inset 3/4". Then cut your 1x8 drawer faces to fit the opening (the ideal is 11 1/4" wide) so that there is an even gap around all sides of the drawer face. Attach the drawer face to the drawer box with 1 1/4" nails and glue.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
We apologize if there was an error in this plan. Please help us out and report any errors here.