Mostly the same. Made smaller spacing for the seat (used 1x4 for spacing) and gave it a back (18" 15% miter) hand formed the front seat board and a bit of an overhang also hand formed the tops of the seat backs and armrest idea was it would be comfy with or without cushions. Ow and it's all construction grade lumber that I water sealed. Thanks for the idea!
Estimated Cost
$126.00
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Thompsons clear water seal applied as I was assembled
Recommended Skill Level
Intermediate
Comments
Ana White
Sun, 09/25/2016 - 09:33
I bet it's super comfy with
I bet it's super comfy with the leaning back! Great job thanks for bragging!