Create a gorgeous media wall by adding towers on either side of the matching center console. Or use it as a linen cabinet or even a nightstand! Free plans by Ana-White.com
Shopping list is per one tower.
1 - Sheet 3/4" Plywood cut into strips 15 3/4" wide, 8 feet long
- 2 - 3/4" plywood @ 15-3/4" x 56 1/4" (Sides)
- 4 - 1x2 @ 15 3/4" (Side Trim)
- 4 - 2x2 @ 59 1/4" (Legs)
- 6 - 2x2 @ 17" (Front/Back Trim)
- 5 - 3/4" plywood @ 15-3/4" x 17" (Shelves)
- 1 - 3/4" plywood @ 15-3/4" x 22" (Top)
- 1 - 1x3 @ 22" (Top)
- 1 - 1x2 @ 22" (Top)
- 1 - 1/4" plywood @ 20" x 55 1/4" (Back)
- 2 - 1x3 @ 11 3/4" (Door)
- 2 - 1x3 @ 23 3/4" (Door)
Have your hardware store cut the 3/4" plywood into 15 3/4" wide strips, 8 feet long. Ask to run the plywood through horizontally so the widths are exactly the same - that's the most important thing! If your hardware store says no, either use a table saw or a circular saw to cut your plywood into 1x16 boards. If you are using a circular saw, clamp a board to the top of your plywood and use it as a guide when cutting - will help you cut straighter.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Pin for Later!
Predrill holes in the acrylic glass and attach to back side of door frames. This acrylic glass should significantly strengthen your door.
NOTE: You may wish to mark the location of your hinges (next step) and notch out a spot for the hinges so you have a nice flat spot to attach hinges - or you could just cut your acrylic glass shorter on the hinge side. This will depend on what type of hinge you use.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.