The Factory cart was really easy to put together.
I used a pocket-hole jig to eliminate any screw heads on the exterior.
The wood I had was already distressed somewhat, but I figured that would add to the 'old' look when ultimately completed.
The most difficult part of this project was finding casters that I liked and that I could afford (those suckers are expensive!) I'm still not 100% sold on the ones I purchased, but will keep my eyes open when out & about for replacements!
The plans posted on Ana-White.com could NOT have been easier to follow.
However, I should like to stress that this coffee table is EXTREMELY low to the ground. One of the first lines on the plan page reads: "This coffee table sits lower than traditional coffee tables." = understatement of the year! (my fault, I should have compared the posted dimensions with an existing coffee table to get an idea before hand)
The plans will make a awesome factory cart height factory cart, but a nearly-uncomfortable height coffee table (As is). In the attached photo, you'll note a foot-rest in the upper left corner as compared to the finished factory cart.
--again, the build was super easy & a LOT of fun because I intended the finish to look worn, I didn't have worry about scratching up the wood during the build. In fact, the kids are looking forward to helping me distress it later! I'll just have to increase the height of the sides to make it usable as a coffee table in our home.
Comments
Pam the Goatherd
Thu, 05/30/2013 - 12:17
Absolutely GORGEOUS!
Absolutely GORGEOUS!
Medickep
Thu, 05/30/2013 - 12:54
Thank you
Thanks!!
spiceylg
Fri, 05/31/2013 - 05:16
Wow
I never heard of using wine barrels in this way! I love it. It came out fabulous!
Medickep
Fri, 05/31/2013 - 05:34
Thanks
Thanks you. People make a lot of stuff out of wine barrels. Chairs, stools, Tables, candle holders, and even serving platters!
Joni
Fri, 05/31/2013 - 06:57
Awesome!
This is awesome! Very cool design. It looks very comfortable! Thanks for the tip on the Australian timber oil; I never knew what would be the best finish for an outdoor piece.
Joni
Fri, 05/31/2013 - 07:03
Awesome!
This is awesome! Very cool design. It looks very comfortable! Thanks for the tip on the Australian timber oil; I never knew what would be the best finish for an outdoor piece.
Medickep
Sat, 06/01/2013 - 11:38
Thank you
It is very comfortable, especially with a glass of wine. I chose the finisher I did because I live in Oregon with a lot of rain!!
Why does everyone's post, including my own show up as duplicate?
Medickep
Sat, 06/01/2013 - 11:38
Thank you
It is very comfortable, especially with a glass of wine. I chose the finisher I did because I live in Oregon with a lot of rain!!
Why does everyone's post, including my own show up as duplicate?
acd4476
Sun, 07/21/2013 - 17:05
plans
Awesome chairs! Beginning to think I need to make some as well. Did you have plans for this project or follow a generic adirondack chair plan?
Medickep
Sun, 07/21/2013 - 19:45
Yes I did
I did have some plans, which made it easier. I didn't use them as designed i.e. tracing, and I also altered the plans some to my liking. I got the plans for 15$ from here: http://www.gcwoodworks.com/Wine-Barrel-Adirondack-Chair-Large.htm
taimeup1
Mon, 07/22/2013 - 05:29
Stunning!!
Absolutely gorgeous!
Medickep
Mon, 07/22/2013 - 07:34
Thanks!
Thank you very much!!